Silversmithing: Prongs #2
         ~ Lisa Kirkeby
This is the second class of three on prongs. In the first class we did
a fairly simple prong setting. This class takes that knowledge and
adds another layer of skill.  
Materials Needed: (kit available day of class)
Sterling 19g 8mm closed jumps (#1368)
Sterling 16g 10mm closed jumps (#28310)
1 foot - 18g sterling round wire
6 inches - 16g sterling half round wire
10mm round CZ

Tools Needed:
Nylon hammer
Steel block with sand bag
Rubber block
Soldering brick & heat proof surface
Easy, Medium and Hard solder
Flux and brush
Butane torch w/ fuel
Miter vise
Jumbo metal file set
and needle files
Flat nose, Chain nose, Round nose, Nylon flat pliers
Heavy duty wire cutters
Bezel pusher
Prong pusher
Steel and Agate burnishers
6-Step looping pliers
Safety glasses, Mask, Magnifiers
Sharpie
Millimeter ruler
Power polishing attachments
Cross-locking tweezers
Fine tip tweezers
Amacote (available at Beadoholique)
Jeweler's saw, blades, lube, bench pin
Technique(s) Used:  
soldering
prongs
stone setting
polishing
.
Skill Level:
Advanced
If you try to register for a class, but it will not add it to the
shopping cart, the class is unfortunately already full.  
Check back next month to see if its offered again!
Silversmithing: Prongs #2
$75.00
Saturday, June 16, 2018, 11-4pm
Instructor:
Lisa Kirkeby